Cabinet Hinge Black Wrought Iron Hinge H Flush 3 H

For the money it was good. One of six was all skiddywhompus and one of the screws paint had filled in the area where the screwdriver goes. But overall these hinges gave my project that nice edge.

The H-Hinges were perfect for our repurposed project. They were the perfect fit and measued as descibed. They kept to the rustic look I was hoping for. I had taken an old 70's night stand bought at Habitat Restore and made it into a small wine bar for an apartment. The hinges worked perfectly and the quality was nice.

I used these inexpensive black matte finish h hinges on an antique dry sink I refurbished. They work wonderfully, and set off the red color nicely.One drawback: I wish they came with Phillips-head screws rather than straight screws. Phillips head are much easier to install using a battery-operated screwdriver.

The hinges came in as expected, no complaints.

They are attractive and work

Built this wardrobe back in the 80’s, wanted to use similar hinges on a new cupboard I plan to build, found them at the same Renevators Supply that I bought the first hinges 30 plus years ago. Quality is about the same. Maybe the metal is slightly thinner. New hinges do not have the pressed edges, which is fine with me. Hinges come with wrinkle paint, but I strip them, heat them with a torch and then drop them in linseed oil. Gives a nice black finish.

Decent enough hinge although a few have required a bit of "adjusting" with a hammer and a block of wood to get them so the leaves are in the same plane. Can't much complain based on the price though.

some of them are good, a few came in rusted so bad they wouldn't work.

I am building a series of roll around cabinets for my bench tools and these really look good on them. I like the rustic look.

Just as described, nice quality product. Fast easy to deal with.

Couldnt find what I needed but I got this and cut it down for my needs.. works great.. just pricey..

Exactly what I was looking for....

The hinges were perfect for my cabinet project. However, the screws were less satisfactory. I had to clear each of the slots to make sure the finish had not made them impossible to drive. A bit of soap on the threads and predrilling with a vix bit--absolutely necessary. I also drove most of the screws by hand since a power (even my 7 volt dewalt) was too hard to keep centered in the slot. A bit of extra work that.slightly deeper slots would have helped even this old hand.

My initial impression of these hinges is that they are thinner material than I expected and the hinge mechanism does not work smoothly even with no load. The finish seems painted on and certainly doesn't give the impression of wrought iron. Ultimately, I would not use these on anything I care about, but for $3 they could be good for some cheap, quick thing.

Before purchase, I read through reviews and questions. Probably MISREAD! My impression was that two hinges would be included. There was but one!On a quality note: the central axis is too small and allows for sloppy hinge movement (especially with only one hinge). A 2nd hinge would solidify the project, but I was in a hurry. It is mailed in a SMALL blister pack that doesn’t offer enough protection. Luckily, it wasn’t bent.